Buying a project bike from a friendly seller feels safe. He seems honest, he knows the bike, and he tells you exactly what is wrong. Then you get it home and start checking, and nothing matches the story. That is what happened to one rider with a cheap 1982 Honda CB650. The motorcycle rebuilder behind @2vintage found the Honda CB650 listed on Facebook Marketplace for $500, about 40 minutes from his house. He offered $300. However, the seller would only drop to $450, so that is what he paid. What The Seller Said According to the buyer, the seller listed a long run of problems. He said he replaced the head gasket and never got it running again. He also said the piston rings had stuck, the pistons now hit the valves, and there was no oil in the engine. On top of that, the seller said he hooked the battery up backwards, heard a pop and lost spark. Still, he said the gas tank was spotless and the bike wore new tires that cost him $300. With 24,597 miles on the clock, the bike looked complete and fairly clean. Nothing Matched The Story Once the bike was in the garage, the checks started. First, he found gasket maker smeared all over the head gasket. Next, he opened the tank and found heavy rust inside. “Did I just get bamboozled?” Then he pulled the dipstick, and the engine was full of fresh-looking oil. Meanwhile, the front brake did not work, a fuel line hung loose, and a fuse had gone missing. By then he was laughing about it. “literally every single thing he’s told me about this bike so far is not true.” Even so, he says the seller seemed like a really nice older man. In his view, the man most likely forgot what he had done to the bike over the years. Afterward, he also admits he could have checked these things before handing over the cash. Finding The Real Fault On The Honda CB650 Next, he turned the engine by hand. Sure enough, it locked up as the valves met the pistons. Fortunately, the oil filter showed no metal, which was a good sign. With the valve cover off, he found a very loose cam chain. Then he lined up the timing marks on the crank and checked the cam. “So, timing is uh extremely off.” So he set the timing correctly, adjusted the chain tensioner and reset every valve to spec. Afterward, the engine turned over without locking up. Spark, Compression And One More Surprise For the electrics, he made a small pigtail with an inline 30-amp fuse. Instantly, the lights, horn, blinkers and starter came back. Better still, all four cylinders showed spark. Then came the compression test, the big worry after the stuck-ring story. The first cylinder read 140, which he says is the bottom of the spec. “Exactly 140. Perfect.” The others came in around 140, with the last one near 132. Finally, he found one more mistake: the coil wires went to the wrong cylinders. Once he fixed that, he hooked up a temporary gas tank for the first start attempt. Lessons For Anyone Buying A Cheap Project Bike This one may still turn out well, but it shows why a seller’s story is only a starting point: Open the gas tank and look inside before you pay. Pull the dipstick yourself instead of trusting the seller. Turn the engine by hand and feel for anything that stops it. Look for gasket maker where a fresh gasket should be. Bring a test light or meter to check for spark and power. Where Things Stand By the end, the timing, valves, fuse and coil wires are all sorted, and the Honda CB650 has spark, fuel and good compression. The video stops on the first start attempt, so whether the $450 bike fires up is still to come.