Chrysler’s big-block wedge V8s took their name from the wedge-shaped combustion chambers in their heads. Of the early ones, the Chrysler 413 became the most famous. The family started in 1958, and the last engine of the design left the line in August 1978. In between, the wedge powered everything from family sedans to Super Stock drag cars. Of course, the Hemi gets most of the glory. Yet for most of the 1960s the wedge did the heavy lifting, because it was cheaper to build and easier to live with. Chrysler kept bolting on bigger carburetors, longer intake runners and higher compression until some versions came with warnings in the owner’s manual. So these seven are our picks for the wedge engines that pushed hardest against the limits of a street car. The verdict is ours, but every rating below comes from factory figures recorded by the sources we checked. Some of these engines idled roughly in traffic, and one was never meant to see a public road at all. 1. 1961 Chrysler 413 Cross-Ram The cross-ram 413 looked like nothing else under an American hood. Two four-barrel carburetors fed it through long ram tubes. The idea was simple physics. As air rushed down the long runners, its momentum helped pack more of it into each cylinder. Chrysler had introduced the 413 in 1959 on the tall-deck RB block, which raised the deck height from 9.98 inches to 10.725. For 1961, Chrysler made the long-ram 413 standard in the 300G. Over-Drive Magazine’s history of the B and RB wedge V8s says that engine used 31-inch ram tubes. As a result, it made 375 horsepower with 495 lb-ft of torque. A year earlier, the 300F had also offered a short-ram version with mechanical lifters, rated at 400 horsepower. That torque figure is the reason this engine earns the first slot. That was a huge number for 1961, and the 300G put it in a full-size luxury coupe. We covered how the 1961 Chrysler 300G outran the Corvette in an earlier story. In our view, this was when Chrysler proved a luxury car could pull like a race car. It also set the template for every Max Wedge that followed. 2. 1962 Plymouth Sport Fury Super Stock 413 Plymouth shrank its full-size car for 1962, dropping the wheelbase from 118 inches to 116. Then it dropped the biggest wedge it could find into that lighter body. The result was the Super Stock 413. Plymouth listed it across the whole lineup, including the bucket-seat Sport Fury that arrived about four months after the other cars. Over-Drive Magazine’s 1962 Plymouth fact sheet lists the Super Stock 413 at 410 horsepower for $375. A 420-horsepower version with 13.5:1 compression also appeared. At first it carried a “Dealer Installed” label, and later Plymouth changed it to “Optional”. That paperwork mattered, because the change was made for NHRA competition. Meanwhile, the Sport Fury was the dressy one, with bucket seats and a center console as standard. Plymouth sold only 4,039 Sport Fury hardtops and 1,516 convertibles that year. So a bucket-seat cruiser with a Super Stock engine was an odd mix of comfort and fury. Plymouth also proved the engine’s pace on the strip. In July 1962, Tom Grove’s 413-powered Savoy, the “Melrose Missile”, ran an 11.93-second quarter-mile, according to EngineLabs. Our take: this was the wedge at its most two-faced, and we love it for that. 3. 1964 Chrysler 300K 413 By 1964 the cross-ram idea was near the end of its run. Even so, the 300K offered it. The standard Chrysler 413 in the 300K made 360 horsepower at 4,800 rpm and 470 lb-ft. However, buyers who wanted more could tick the 390-horsepower ram-induction engine with dual four-barrels, priced at $375. Over-Drive Magazine lists that ram engine at 485 lb-ft. Those figures come from the Chrysler 300 Club’s 1964 300K page. It also notes that only the 300K offered the 390-horsepower engine. Production stayed small. Chrysler built 3,022 hardtops and 625 convertibles, and the hardtop started at $4,228. What makes this one fun is the contrast. The 300K was a plush, letter-series car built for fast highway cruising. At the same time, the optional engine used short ram tubes and two carburetors. That was the recipe Chrysler had used to chase horsepower all through the early 1960s. In our view, the ram-induction 300K is the best way to see the cross-ram idea in its final form. Because so few were built, finding one with the original dual-quad setup takes patience. 4. Dodge Polara Max Wedge Dodge called its version of the Max Wedge the Ramcharger, and the name fit. First, for 1963, NHRA capped factory Super Stock engines at 427.2 cubic inches. Chrysler answered by opening the bores to make a 426, according to EngineLabs’ history of the Max Wedge. The 11:1 engine made 415 horsepower, and the 13.5:1 version made 425 horsepower and 480 lb-ft. Chrysler sold the 426 Max Wedge as a race-only engine. Even so, it did not stay in stripped-out race cars. For 1964, EngineLabs lists the Polara and Polara 500 among the B-body Dodges that could carry it. As a result, a race engine could sit in Dodge’s dressier full-size line. If you want the deeper story, we broke down the hidden features of the Dodge 426 Max Wedge engine separately. Chrysler itself admitted this was not a normal street motor. The 1963 owner’s manual warned that the cam caused “a rough idle operation and lazy low-speed response”. A factory bulletin also said wide-open throttle bursts had to stay under 15 seconds to prevent engine damage. That is as close as a carmaker gets to saying “too much for the street”. So we think the Polara earns its place. 5. 1970 Dodge Challenger R/T 440 Six Pack The 440 Six Pack was the wedge’s answer to the street Hemi, and it was far easier to own. Dodge introduced it in the middle of the 1969 model year and dropped it at the end of 1971. Plymouth sold the same engine as the Six-Barrel. SlashGear’s guide to 440 Six Pack cars explains the setup. Three Holley 2300-series two-barrel carburetors flowed a combined 1,350 cfm. Dodge rated it at 390 horsepower and 490 lb-ft, compared to 375 horsepower for the regular 440 Magnum. In normal driving, though, only the center carburetor did the work. Then the front and rear units opened up under heavy throttle. In the new 1970 Challenger R/T, a three-speed manual came as standard with the Six Pack, while a four-speed was optional. Dodge sold about 83,000 Challengers that year. The option had started strong, too. SlashGear says Dodge built nearly 2,000 Super Bees with the Six Pack in 1969, against 125 with the Hemi. We explained how the 440 Six Pack setup worked in an earlier piece. Our take: a pony car with 490 lb-ft on the tires of the day was right on the edge. 6. 1964–1965 Chrysler 383 wedge V8 The 383 sat on Chrysler’s original low-deck B block, so it was the shorter, lighter cousin of the Chrysler 413 and 440. That did not make it mild. The B family had started in 1958 at 350 and 361 cubic inches, and the 383 grew out of it a year later. In 1959 Dodge offered a Super D-500 version rated at 345 horsepower, according to Over-Drive Magazine. Plymouth’s version that year carried the Golden Commando name. By the mid-1960s the 383 had settled into a role as the everyday performance engine. Over-Drive lists it at 320 horsepower in Dodge and Plymouth cars for 1964 and 330 horsepower for 1965. Those numbers sound tame next to a Max Wedge. Still, they came from the same engine family that Chrysler also put in the 1965 Windsor, rated at 270 horsepower there. That is exactly why we picked it. In fact, a 383 in a plain-looking 1965 sedan gave buyers serious acceleration without any race-car fuss. It also set up the later 383 Magnum, which borrowed heads and a cam from the 440. If you’re shopping for a mid-1960s Mopar today, a numbers-matching 383 is the sensible way into big-block ownership. 7. 1970 Bristol 411 (Chrysler 383) The wedge also crossed the Atlantic. Bristol, the small British maker, began fitting Chrysler V8s with the Type 407 in 1961. It also paired them with the TorqueFlite automatic. For the 411, launched in 1969, Bristol moved up to the big-block B engine of 6,277 cc, which is the 383. The Bristol Owners’ Club history of its Chrysler engines gives the 411 a top speed of 140 mph. It also quotes the road tester John Bolster, who called it “the fastest true four-seater touring car”. Later, the Series 4 cars moved to an even larger 6,556 cc engine. Moreover, the original 383 gave the 411 an estimated 30 percent more power and torque than the 410 it replaced. This is the most civilized car on our list. After all, it was a British four-seater with a Detroit big-block under the hood. In our view, that is what makes it fit the theme. A gentleman’s express that could run 140 mph in 1970 was plenty for British roads. The club records that the 411 ran through four further series, and its successor, the Type 412, did not arrive until 1975.