Toyota is recalling roughly 62,000 newer pickups in the U.S. over the risk that the camshaft in the engines of a small number of those trucks could snap, causing engine failure, possibly while driving. Specifically, the safety campaign covers Toyota Tundras from model years 2022 and 2023; and 2025 and 2026 if equipped with the company’s 3.4-liter twin-turbo V6, the V35A-FTS. The recall does not apply to 2024-model-year Tundras, nor to hybrid versions or Sequoia SUVs equipped with the same engine. Transport Canada has yet to make public a Canadian counterpart to this recall, so it’s unclear how many, if any, trucks are affected in Canada. Toyota has also traced the problem to one particular batch of camshafts from one parts supplier – all installed on bank one of these V6s – and so is rather confident in noting that just about 300 trucks out of those 62,000, or about 0.5%, will actually have this defect. On these affected trucks, though, the camshafts may have been manufactured improperly, and so “could snap during driving,” says the National Highway Traffic Safety Administration. If this happens, the engine will suddenly fail, and the Tundra will lose all power to the wheels, which can pose a hazard, depending on whether and at what speed the pickup is driving. The remedy is simple: Toyota technicians will inspect the camshaft and, if necessary, replace it. The Toyota Tundra was previously wrapped up in a similar engine-failure recall, one launched in 2024 and expanded last year, and then again earlier this year, to cover nearly 17,000 examples of the truck in Canada. The defect in that case was tied to the same V35A-FTS, and specifically metal debris in the crankcase damaging their crankshafts.