A check engine light is easy to ignore. A flashing one is a different story. One mechanic says a 2018 Chevrolet Silverado 1500 arrived on a tow truck after its owner saw exactly that, and the cause turned out to be deep inside the engine. The shop owner who posts as @RainmanRaysRepairs walks through the diagnosis step by step. The truck has the 6.2-liter V8 and 110,280 miles on the clock. He notes it is not one of the later trucks covered by a recall he mentions. Why The Silverado’s Flashing Light Mattered He reads the work order before he starts. “Customer states there’s a check engine light that is on and it’s flashing while driving.” He explains that a flashing light means a misfire bad enough to hurt the catalytic converters. Unburned fuel goes into the exhaust, where it builds up and burns in the converters. That overheats them until they crumble and clog. A steady light is less urgent, he says, but a flashing one means damage is already happening. His advice is to stop driving when the light flashes. The light was off when he started the truck, but the engine felt rough. His scan tool found code P0300, a random misfire. The history counter showed about 14,000 misfires on cylinder three. Watching A Valve Through A Camera He says this engine has a history of trouble with the lifters used by its cylinder deactivation system. Cylinder three, he believes, is not one of the deactivating cylinders, so he wanted to see for himself. Next, he pulled the spark plug and fed a borescope camera into the cylinder. Then he turned the engine over by hand at the crankshaft. He opened the valve, stopped turning and watched to see if it stayed open, as it should. “It opened and then closed all by itself.” To be sure, he repeated the test several times on camera. Each time, the valve crept shut on its own. That is a lifter bleeding down, according to the mechanic. The valve does not open fully, and the cylinder misfires. “That’s why it’s misfiring. Bad lifters.” He also emptied the oil catch can the owner had installed. It held very little oil, a sign the owner had kept up with it. Two Ways To Fix It There are two options for the owner. The smaller job pulls the cylinder heads and swaps the lifters, at roughly $5,600 to $5,800 after tax and parts by his estimate. A bigger job takes the engine out. It would get a new camshaft, upgraded lifters and the deactivation system removed, plus a full reseal. That one runs $8,000 to $11,000, depending on the parts. As an example, he says one premium lifter set runs about $900 and an aftermarket set about $325. He leans toward the full job if the owner plans to keep the truck, since the heads have to come off either way. He calls that approach buy it once, cry once. What We Would Take From This One Misfires can start small and get expensive fast. Here is what we would keep in mind: Pull over and stop driving when a check engine light starts flashing. Ask the shop which cylinder is misfiring and how many times it has been counted. Ask whether a cheaper fix leaves the original weak point in place. Get prices for both a minimum repair and a complete one before you decide. Think about how long you plan to keep the vehicle when you choose between them. Where Things Stand The mechanic says he will write up a basic option, a premium option and the repair he would choose if it were his truck. The decision is now up to the owner. He says he will post an update if the customer approves the work.