Plenty of us have a car in the garage that we swear we will finish one day. For one couple, that car was the 1970 Camaro they took on their first date. The husband pulled its tired engine around 1985 to build a better one. He never got to put it back in. The story is told in a new episode from the classic-car team at @Hagerty. Two of its hosts traveled to the widow’s home to finish the job. According to the hosts, Cindy’s husband, Larry, bought the RS/SS in the early 1980s and passed away a few years ago with the car still in pieces. Finishing Larry’s 1970 Camaro The hosts say the Camaro had been sitting for about 40 years. Larry’s rebuilt small-block was waiting on a stand, and the engine bay had already been sanded. One host cleaned and painted the bay while the other painted the engine and bolted on the intake, water pump and starter. They primed the oiling system before the first start and saw about 60 psi on a gauge. They also checked the dates on the engine. Because it had been machined during the rebuild, the stamped code was gone, so they could only say the dates line up with the car. While bolting up the transmission, they spotted a VIN stamped on the case. It matched the car. The hosts think the engine hoist in the garage is the same one that pulled the engine 40 years ago, and it lowered the engine back in. A longer driveshaft from Larry’s stash fit perfectly. A borrowed carburetor bowl replaced one with ruined threads. A Scare On The First Start The engine fired, but something sounded wrong right away. “Exhaust leak or throwing a rod?” The first problem was a missing exhaust piece between the manifold and the pipe. The hosts were three hours from their own shop with no spare. Then one of Larry’s friends walked in carrying exactly the part they needed. A loud banging noise remained. They checked the valvetrain, which looked fine, and slept on it. The next day they found the culprit. The exhaust manifold was hitting a head bolt on the aftermarket heads. They ground it for clearance and stacked thicker gaskets. After that, the engine settled into a smooth idle. The First Drive In 40 Years The rear brakes were seized, so the crew replaced the wheel cylinders and bled the system. New plug wires cleared up a small miss. Then the Camaro rolled off the lift past a crowd of onlookers and onto public roads for the first time in four decades. It climbed a steep hill, and the hosts were happy with the brakes and power steering. One host noted that the car’s last drive came before he was born. Then it was Cindy’s turn. “I have been waiting 40 years to drive this car again.” She drove it through the same streets the couple used to cruise. She called the project her last little hurrah for him. “I am just in heaven right now alongside with him.” What We Would Take From This One An unfinished project car can wake up again, but a long sleep leaves its mark. Here is what we would keep in mind: Prime the oil system before the first start on an engine that has sat. Check the brakes before the first drive, since wheel cylinders often seize. Test-fit exhaust parts with gaskets, because tight clearances can mimic serious engine noises. Label and keep the spare parts a builder leaves behind, because they may save the day. Ask the original builder’s friends for help, since they often know the car best. Where Things Stand Larry’s Camaro runs and drives on its rebuilt engine. Cindy plans to add headers and a new exhaust later and is already picking a car show. They did the work in Larry’s own shop, using parts he had collected. The hosts closed the episode with a short tribute. “This one was for Larry.”