Nearly 10,000 owners belong to the Cummins High Mileage Club, according to Jalopnik, and dozens of owners have passed a million miles on a Cummins 5.9 diesel. Numbers like that don’t happen by accident. They come from an inline-six layout that is long, smooth and hard to kill. These are our picks for the diesel sixes we’d trust when the load is heavy, the road is rough and help is far away. The verdicts are ours. However, the specs come from the engine history sources listed at the end. 1. Cummins 5.9 diesel The 5.9 started life in 1984 as an industrial engine developed with Case. Then Dodge put it in the Ram pickup in 1989. Jalopnik lists the early rating at 160 horsepower and 400 lb-ft of torque, far more torque than the rival Chevy 6.2-liter and Ford 7.3-liter diesels. It uses a cast-iron block and head, seven main bearings and a steel gear drive instead of a belt or chain. We’ve covered the secrets behind the Cummins 5.9 before, and its toughness is no secret at all. 2. Mercedes-Benz OM603 diesel six The OM603 is a 2,996cc inline-six that Mercedes installed leaning 15 degrees to the right. In the turbocharged 300 TD Turbo wagon, Mercedes rated it at 143 horsepower at first, then 147 from September 1988. Until August 1987, that wagon was sold only for export to North America. In our view, few car engines were better suited to long, hot interstate miles with a full load in the back. 3. Toyota 1HZ diesel six Carsguide calls the 1HZ “the prince of non-turbo diesels,” and it’s hard to argue. The 4,164cc six has a cast-iron block and head, seven main bearings and no turbo to fail. It made 96kW and 285Nm in Land Cruisers from 1990 until 2007. Some operators report a million kilometers before major work. That’s why it suits the outback so well, and why 1990s Land Cruisers earned their reputation. 4. Toyota 1HD-T turbodiesel six The 1HD-T was the turbo partner to the 1HZ when the 80 Series Land Cruiser arrived in 1990. It also shared the 4.2-liter size but used direct injection. According to Carsguide, it made 122kW at 3,600rpm and 361Nm at just 1,400rpm. That low-end pull is what you want in sand, mud or on a steep climb. It lasted only until 1992, but it started an entire family of Toyota turbo-diesels. 5. Nissan RD28 diesel six Let’s be honest about this one. Carsguide notes the RD28 has a reputation for being “gutless” in a 2.3-tonne Patrol. It also lists real faults, from a loosening crank pulley to cracked heads. Yet the 2.8-liter six has a cast-iron block and seven main bearings. Its four-cylinder ZD30 successor proved less reliable, too. So for an owner who checks that pulley nut, we’d take the RD28 on a long, remote trip. 6. Volvo D24 diesel six The D24 came from Volkswagen’s LT van, which got the engine in 1978. Volvo then fitted it to the 244 D6, which The Autopian calls the world’s first six-cylinder diesel car, with 82 horsepower. Performance was modest. Instead, the engine’s gift was endurance. IPD USA told The Autopian the engines were “very reliable … to the point that they generally got ignored and didn’t get maintained properly.” We’d take that as high praise. 7. Caterpillar 3406 diesel six Caterpillar introduced the 3406 in 1973, and the 14.6-liter inline-six went everywhere. It powered Class 8 trucks, bulldozers, boats and generators. The mechanical 3406A, built until 1987, made 310 to 425 horsepower, according to IPD. Later versions climbed far higher. Many of these engines are in service today. For us, a big Cat in a long-hood Kenworth is the picture of a diesel that doesn’t quit. 8. Mercedes-Benz OM352 diesel six Daimler-Benz launched the OM352 in 1964 as a direct-injection replacement for its pre-chamber OM 322. The 5.7-liter six made 126 PS and 353 Nm. In addition, the switch to direct injection cut fuel use by about 15 percent. A boosted OM 352 A followed in 1966 with 150 PS. Mercedes used the engine in trucks, buses and the go-anywhere Unimog into the 1980s, which tells you how much it could take.