Most people see a solid axle on a Jeep XJ and accept the clearance limit. Zeph Gage turned a Ford 9-inch upside down instead. His rear end now clears a five-gallon bucket with about three inches to spare. When he pitched the idea, his co-host's reaction was, "This is too logical." According to a YouTube video by Outdoor Auto and Gage Boys' Garage, which The Drive reported, the whole axle cost about $4,000. A comparable 74Weld set runs around $20,000. Portals Only Where They Count Gage kept the Dana 60 up front. Portals there would force the engine and axle packaging higher, and the front can steer its tires onto tall rocks anyway. The rear can't steer, so it's the end that drags and hangs up. Running a solid front and a portal rear is called a "mullet" in the RC crawler world, where the setup is common. On the Jeep, the swap adds about six inches of clearance: two from trading the old Sterling axle for the Ford 9-inch, and four from the portals. Ride height and shock position don't change. Image Credit: Gage Boys Garage Making a Humvee Gearbox Work The Humvee's two-gear portal box has a catch: "A two-gear portal in effect makes your rear tires go backwards." The fix is mounting the differential upside down, because "two negatives make a right." A normally low-pinion Yukon third member becomes a budget high-pinion unit, and the pinion still rides the strong drive side of the ring gear. The portal box's 1.92:1 reduction also cuts the torque load on the differential almost in half. Gage paired it with a 2.50:1 ring and pinion, a drag-car ratio, which gives an effective ratio near 4.85 to match the front axle. Jesse Haines, whose shop supplies the adapters, reports that his flipped 9-inch builds need no oiling changes, just oil filled halfway up the tube. Fabrication to Make It Fit None of this bolts on. Gage built his own brackets and a gusset, and he lowered his link mounts to line up with the new wheel-mount height. This matters on a 5,000-pound rig, since the portal box acts as a lever on the axle. Brakes took the most improvizing. A deep-dish rotor would hit the portal box, so he had a two-piece mild-steel rotor made. He paired it with Ford Fusion calipers that cost about $100 for the pair. They're compact and include an electric parking-brake solenoid. Image Credit: Gage Boys Garage Is It Tough Enough? Haines told Gage that the gears would fail first, so Gage chose his helical-cut set. Haines says about 40 sets have shipped with no breakage reports. The 35-spline axle shafts see half the load, and the lower gear is 46-spline. Gage says he's "over the moon." A follow-up video will cover how it performs on the trail.