Building a custom camper van sounds like a dream until you actually start cutting the wood.Every single panel in a van is a challenge. Metal walls bend, wheel wells stick out at weird angles, and straight lines basically do not exist inside a cargo vehicle. I spent weeks measuring and cutting custom plywood panels, but one specific section had me stumped for a long time. It was the piece meant to flush-fit around our wheel well box and step build.The fit? Pure magic. I grabbed the custom-cut sheet of plywood, guided it past the exposed wall insulation, and pushed it flush against the frame. It clicked into place with absolute perfection.AdvertisementAdvertisementWhen you spend hours with a jigsaw and a tape measure, moments like this feel like winning a championship. Every line matched the curvature of the wall without leaving a gap. Getting that flush panel installed means I can finally move on to the trickiest phase of this entire build: setting up the main electrical panel and power system.Building your own rig is a game of patience and precision. You measure three times, cut once, and pray the metal frame did not warp while you were working. When a complex cut slides in on the first try, the feeling is unmatched.Now that this wall section is officially locked down, the interior is finally looking like a real home on wheels. Next up is running the wiring and setting up our off-grid power hub. Stay tuned, because the build is moving fast now.