The Cadillac 346 V8 started life in 1936 as a luxury-car engine, and within a decade it was pushing light tanks through Europe. That jump from velvet seats to steel tracks says a lot about how Cadillac built its V8s. They were made to be smooth, but they were also made to be tough. Later Cadillac engines went racing at Le Mans, hauled heavy luxury coupes at highway speed and lapped the Nürburgring in a four-door sedan. Not every Cadillac V8 earned a good name, of course. The cylinder-switching V8-6-4 of 1981 is still remembered for its problems, so it stays off this list. These eight are our picks for the Cadillac engines that kept running when the job got hard. Some faced war, some faced 24 hours of flat-out racing, and some simply carried huge loads for years. The verdicts are our opinion. The numbers behind them come from the records. 1. 1941 Cadillac Series 62 346 flathead V8 Cadillac’s 346 was the first monobloc Cadillac V8, with the cylinders and crankcase cast as one iron piece. That made it cheaper to build than the engine it replaced. In 1936 the Series 75 version made 135 horsepower, and from 1941 through 1948 every Cadillac used the 346, according to Mac’s Motor City Garage. The 1941 Series 62 is a good way to meet it. It was the mainstream Cadillac of its day, and the side-valve engine under its hood had no overhead valves at all. The valves sat beside the cylinders in the block, which kept the design simple. In fact, Mac’s calls the engine one of the division’s most successful and dependable powerplants. On the other hand, it was heavy. The Cadillac V8 weighed nearly 900 pounds, while Ford’s V8 came in under 550. Our take: the proof of this engine’s toughness came after the showroom. The same basic V8 was soon drafted for military use, as the next item shows. If you shop for a 1941 to 1948 Cadillac today, a healthy 346 is part of the appeal. Check for overheating history, since a flathead routes hot exhaust through the block. 2. 1944–1945 M24 Chaffee twin Cadillac 346 V8 The M24 Chaffee light tank came out of Cadillac’s own engineering department in Detroit. The Tank Museum in Britain notes that the Cadillac Division of General Motors designed it. It ran on two Cadillac engines and gearboxes mounted in the back. Those engines were twin 346 V8s, the same family that powered Cadillac’s cars, and the earlier M5 Stuart used the pairing too. Builders turned out 4,731 Chaffees, according to the Tank Museum. The tanks reached Germany in late 1944 and went into action that winter. Later, they fought in Korea and Vietnam, and some stayed in service into the 1990s. A few Chaffees with Britain’s 7th Armoured Division also rolled through the Berlin Victory Parade at the end of the war in Europe. French crews also used ten M24s at Dien Bien Phu, where they fired about 15,000 shells during the long siege. In our view, no engine on this list faced harder driving than this one. Mud, snow, jungle heat and battle damage are about as extreme as conditions get. That a luxury-car V8 kept a tank moving through all of it is the best argument for Cadillac’s engineering we know. 3. 1950 Cadillac Series 61 5.4-liter V8 (Le Mans) Cadillac switched to a new overhead-valve V8 for 1949. Ward’s later put Cadillac’s V8s on its list of the 10 best engines of the 20th century, noting the 1949 design’s 160 horsepower from 5.4 liters. A year after launch, Briggs Cunningham took two of these cars to the 24 Hours of Le Mans. One was a nearly standard Series 61 coupe. The French nicknamed it “Petit Pataud,” and Miles and Sam Collier drove it. The car ran a 331-cubic-inch V8 rated at 160 horsepower at 3,800 rpm. It finished 10th overall and averaged 81.5 mph for the full 24 hours, according to the Revs Institute. Meanwhile, the Ferraris and a Simca-Gordini dropped out. In other words, the Cadillac averaged only about 8 mph less than the winning Talbot. Both Cunningham cars also carried pit-to-car radios. Our take: a nearly stock two-door Cadillac finishing Le Mans is still one of the great stories in American racing. The engine simply kept running for a day and a night. Today the car lives at the Revs Institute in Naples, Florida, where you can see it in person. 4. 1950 Cunningham Le Monstre Cadillac 5.4-liter V8 The second Cunningham Cadillac looked nothing like a showroom car. It wore a slab-sided aerodynamic body that was refined in the Grumman Aircraft wind tunnel. The French promptly named it “Le Monstre.” Underneath, it used the same 5.4-liter Cadillac V8 family as the coupe. The race did not start well. On lap 2, Cunningham slid the car into the sandbank at Mulsanne and spent 15 minutes digging it out. After that, the gearbox let him down, and the car was stuck in top gear for most of the race. Even so, Cunningham and Phil Walters finished 11th after 232 laps, one lap behind the sister car. Both Cadillacs also held their positions for virtually the whole race. Running a full day in one gear puts huge strain on an engine. It has to pull from low speed out of every slow corner, and then it has to run flat out down the straights. In our view, that makes Le Monstre’s finish an even better test of the V8 than the coupe’s 10th place. As a result, it earns its own spot here. 5. 1964 Cadillac Sedan deVille 429 V8 By 1964 Cadillac had stretched its V8 to 429 cubic inches with a 4.13-inch bore and a 4-inch stroke. Power rose to 340 horsepower, and torque reached 480 lb-ft. The 429 stayed in service through the 1967 model year, so it powered four seasons of full-size Cadillacs. By comparison, the 1956 365-cubic-inch V8 had made 285 horsepower, so the 429 was a big step in less than a decade. The Sedan deVille is where most buyers met it. This was a big four-door car built for long highway trips with a full load of passengers and luggage. That kind of work is less dramatic than a race or a war, but it is still demanding. Hot summers, steady high speeds and heavy loads punish weak engines over time. Our take: 480 lb-ft is a lot of torque for a family sedan, and it meant the 429 rarely had to work near its limits. In our view, that headroom is why this engine suits our list. If you want a 1960s Cadillac for real road trips, a well-kept 429 car is a smart place to start. Budget for cooling-system work, which any 60-year-old V8 will need. 6. 1970 Cadillac Eldorado 500 V8 For 1970 Cadillac pushed displacement to a full 500 cubic inches, or about 8.2 liters. Hagerty notes that the 1970 Eldorado sent 400 horsepower to its front wheels. Cadillac also rated the engine at 550 lb-ft of torque, gross, and kept it exclusive to the Eldorado that year. Hagerty goes further and calls the 1967–70 Eldorado possibly the most influential Cadillac of all time. Front-wheel drive with that much torque was a bold idea in 1970. The engine had to turn a heavy personal-luxury coupe through its front axle without drama. Emissions rules then cut the numbers year by year. By 1976, the 500’s final year, its rating had fallen to 190 horsepower. However, an optional Bendix electronic fuel injection system lifted that year’s output to 215 horsepower. For more on how the big engine came together, read why Cadillac’s 500 V8 looked ridiculous on paper and brilliant in reality. Our take: the early 500 had so much torque that it loafed through everyday driving. If you shop for one, the 1970 car carries the highest rating. However, check the front-drive hardware carefully, because it handled a lot of twist. 7. 2004 Cadillac CTS-V LS6 V8 The first CTS-V borrowed its engine from the Chevrolet Corvette. The 2004 and 2005 cars used the C5 generation’s 5.7-liter LS6 V8, rated at 400 horsepower at 6,000 rpm. For 2006 and 2007, Cadillac switched to the 6.0-liter LS2. Cadillac also took the CTS-V racing in SCCA World Challenge. The first-generation car competed from 2004 to 2007. It won the manufacturer’s championship in 2005 and again in 2007. Later, the CTS-V coupe returned to the series and won back-to-back manufacturer’s titles in 2012 and 2013. In other words, a sedan that buyers could order from a dealer was winning championships. Sprint racing like that means full throttle, hard braking and high heat for lap after lap. We think that record shows how well the LS6 suited a sport sedan that would be pushed hard. For a closer look at the street version, read when Cadillac built the CTS-V LS6 sedan and what it costs today. If you buy one, the LS6 years are the purist’s pick. Look for full service records, because a car built for this kind of driving may have seen track days. 8. 2009 Cadillac CTS-V LSA V8 The second CTS-V moved to a supercharged 6.2-liter LSA V8. Cadillac rated it at 556 horsepower at 6,100 rpm and 551 lb-ft at 3,800 rpm, Carscoops reported when the official numbers came out. The same report gave a 0-60 mph time of 3.9 seconds and a quarter-mile run of 12 seconds at 118 mph. For a four-door luxury sedan, those are remarkable numbers, in our view. Before the car went on sale, Cadillac sent a 2009 CTS-V to the Nürburgring Nordschleife. In May 2008, the sedan lapped the circuit in 7:59.32 on factory-spec street tires. At the time, Cadillac said the time appeared to be the fastest publicly documented lap for a production sedan. Our take: the Nordschleife is one of the hardest tests any road car can face, with long full-throttle sections and constant elevation changes. A supercharged V8 that survives that pace earns its place on this list. To see how the car changed Cadillac’s image, read how the 2009 Cadillac CTS-V reset the brand’s image. Its 7:59.32 lap from May 2008 remains the number most fans remember.